Blog and Resources

Simple Multi-Step Clamp and Sensor Installation

Posted by Jared VanOuse on Sep 3, 2019 5:15:00 PM

 

Sensor Networks is pleased to announce our new clamps for microPIMS monitoring systems. The new clamps are either band or magnetic and compatible with Ultra-High-Temp and Corrosion Dual microPIMS. The simple installation process allows for increased speed and safety when installing corrosion monitors in hazardous environments. Here are the steps for installation:


New Clamps

Step 1 – Clean and smooth the surface

Clean FINAL

Step 2 – Place clamp around pipe

Place FINAL

Step 3 – Tighten the T-Bolt

Tighten FINAL

Step 4 – Slide the top bracket over the probe. Remove the probe cap to slide on and replace the cap to secure the bracket.

Sep 4 photo

Step 5 – Place a drop of glycerin on the face of the probe

Drop FINAL

Step 6 – Place couplant foil on the face of the probe

Place Couplant FINAL

Step 7 – Carefully lower the probe face into the bracket hole. Apply pressure so the couplant foil is squeezed between the probe and the pipe surface

Carefully FINAL

Step 8 – Tighten down the hex head bolts

Tighten Bolts FINAL

Success! – Correct tightness can be evaluated by the quality of the signal, thickness, and temperature readings. Additional tightening may be required.

Scan

Topics: Corrosion Monitoring

About Sensor Networks, Inc.

Sensor Networks, Inc. has identified a problem in today’s world: when it comes to complex asset integrity, there are obstacles and challenges that you will face along the way. Where there are problems, innovative solutions should be created to fix them. With that basic mission in mind, Sensor Networks, Inc. was born.

Subscribe Here!

Recent Post